- 摘 要
-
（1 中國建筑標準設計研究院， 北京 100048； 2 柳州東方工程橡膠制品有限公司， 柳州 545005）
［摘要］在GB/T 9978-1—2008標準升溫條件下，進行了隔震層防火墻防火構造耐火試驗及與直徑1 200mm橡膠隔震支座的防火構造耐火試驗，考察耐火時間對隔震層防火墻防火構造及隔震支座表面溫度的影響。試驗結果表明：隔震層防火墻防火構造耐火4h，完整性和隔熱性完好；隔震支座防火構造耐火3h，隔震支座表面溫度最高為103-6℃，隔震支座外觀完好。通過擬靜力試驗，考察了隔震層防火墻防火構造在地震力作用下的可恢復性，證明了建筑隔震防火構造是可靠的。
［關鍵詞］隔震防火構造； 耐火試驗； 耐火時間
中圖分類號：TU352-12文獻標識碼：A文章編號：1002-848X(2016)19-0076-07
Experimental study on building isolation fire protection construction
Du Zhichao1, Deng Xuan1, Liu Jinzhang2, Zeng Demin1, Jiang Hangjun1, Xu Hongfei2
(1 China Institute of Building Standard Design & Research, Beijing 100048, China；2 Liuzhou Orient Engineering Rubber Products Co., Ltd., Liuzhou 545005, China)
Abstract:Under GB/T 9978-1—2008 standard heating condition, fire resistance test on the isolation layer firewall fire protection construction was conducted as well as fire resistance test on fire protection construction with rubber isolation bearing of 1 200mm diameter, to inspect the influence of the fire resistance time on isolation layer firewall fire protection construction and surface temperature of isolation bearing. The test results show that: the fire resistance time of isolation layer fire protection construction is 4h, and integrity and thermal insulation is intact. Fire resistance time of fire protection construction of isolation bearing is 3h. The isolation bearing′s surface temperature is up to 103-6℃ and isolation bearing appearance is intact. Based on the quasi static test, the recovery of the isolation layer firewall fire protection construction was investigated under the earthquake, which proves that the building isolation fire protection construction is reliable.
Keywords:isolation fire protection construction； fire resistance test； fire resistance time
作者簡介：杜志超，碩士，工程師，Email：dzc_2006@126.com。
- 下載地址
-
