- 摘 要
-
（多維聯合集團有限公司， 北京 100070）
［摘要］綜合考慮高強鋼箱形軸壓和偏壓構件初始缺陷(整體、局部初彎曲)、殘余應力以及幾何、材料非線性的影響，采用有限元軟件ANSYS建立有限元模型，并利用已有試驗數據分析網格劃分方式、初始缺陷施加形式等對有限元模型計算結果的影響。研究結果表明，采用殘余應力文件進行兩次導入，能獲得較好的殘余應力模擬效果；單元縱橫比控制在1∶3之內時，能保證有限元模型得到較好的分析結果；基于本文分析所建立的有限元模型能很好地模擬相關構件。
［關鍵詞］高強鋼； 焊接箱形截面； 局部-整體相關屈曲； 有限元模型
中圖分類號：TU391文獻識別碼：A文章編號：1002-848X(2017)15-0049-05
Buckling FEM modeling and verification for high-strength steel box section components under axial and eccentric compressions
Liu Xiang
(Duowei Union Group Co., Ltd., Beijing 100070, China)
Abstract:Finite element software ANSYS was used to establish finite element models of high-strength steel box section components under axial and eccentric compressions, considering the member initial geometric imperfections (the whole and local initial bending), the residual stress and the influence of geometric and material nonlinear, and existing test data were used to analyze effects of mesh division mode and the initial defect loading form on the calculation results of finite element model. The research results show that using residual stress documents for twice imports can obtain better simulation effect of residual stress. Unit aspect ratio controlled within the range of 1∶3 can ensure good analysis results of the finite element model. Finite element analysis model established based on study can well simulate the related components.
Keywords:high-strength steel; welded box section; local overall interaction buckling; finite element model
作者簡介：劉翔，碩士，工程師，Email:.xiangxianxiaxi@hotmail.com。
- 下載地址
-
