- 摘 要
-
(沈陽建筑大學土木工程學院， 沈陽 110168)
［摘要］針對現有需要多次組模澆筑的固定模位式復合墻板模具拆卸困難、內葉墻模具達不到使用壽命和每套模具只能生產一種墻板等缺點，采用三維設計軟件SKETCHUP與AUTOCAD平面制圖相結合的設計方法對固定模位式復合墻板模具進行設計，并采用SAP2000軟件對所設計的復合墻板模具受力狀態進行計算模擬分析，對其底模及底模支架和內葉墻模具的承載力和剛度進行校核。復合墻板模具在模擬計算分析過程中，其承載力和剛度均滿足相應標準。通過計算模擬分析表明：設計的模具能在各種工況條件下正常使用。
［關鍵詞］復合墻板； 模具； 承載力； 剛度
中圖分類號： TU398 文獻標識碼： A 文章編號： 1002-848X(2015)S2-0509-04
Simulation calculation analysis of composite wallboard mould design
Xu Chunyi, Zhao Huan, Chen Fengchuang
(Civil Engineering College, Shenyang Jianzhu University, Shenyang 110168, China)
Abstract: In view of shortcomings of composite wallboard mould in fixed mode type of multiple assembly mould pouring, inner lobe mould can not reach life, each mold can only produce a wallboard and so on, the fixed mode composite wallboard mould was designed combining three-dimensional design software SKETCHUP and AUTOCAD. Thestress state of composite wallboard mould was calculated and analyzed using the SAP2000 software, the bearing capacity and stiffness of each part of thebottom mould and bottomm stent and inner lobe mould of composite wallboard in fixed mode type were checked. In the process of simulation calculation analysis of composite wallboard mould, bearing capacity and stiffness meet the corresponding standards. Simulation calculation analysis shows that the composite wallboard mould design can be normally used in all kinds of conditions.
Keywords: composite wallboard; mould; bearing capacity; stiffness
作者簡介：徐春一，碩士生導師，副教授，Email：xuchunyiyi@163.com。
- 下載地址
-
